WAGO - 2210-1307 EARTH TERMINAL BLOCK WITH PUSHBUTTON, TEST PORT, 3 CONDUCTOR, 4MM²; GREEN/YELLOW, PUSH-IN CAGE CLAMP, EX APPROVED

Earth Terminal Block with Pushbutton, 3 conductor, 10 mm², Green/Yellow, Ex Approved

This capable ATEX rated green and yellow earth/grounding terminal block, suitable for Ex applications, has been designed for use in areas where the presence of vapours and gases in the operating atmosphere could prove dangerous if ignited by an errant spark. This terminal block fit 35mm DIN Rails and incorporates cage clamp technology, and is around 30% smaller than standard terminal blocks.

Versatile, this WAGO TOPJOB S single level ground DIN rail mount terminal block with pushbutton and test port, enables easy connection, the clamping point is opened by actuating the push-button with any common tool. The orange push-button allows the actuator to be clearly and quickly distinguished from the conductor entry.

This DIN rail mount terminal block is backed by the renowned reliability of push-in cage clamp technology, offering the additional possibility of connecting solid and stranded conductors, as well as fine-stranded conductors with gas-tight crimped ferrules, push fit, no tools needed. For suitable endplates see part numbers 2010-1391 and 2010-1392.

The WAGO TOPJOB S range of DIN rail terminal blocks can also be fitted with marker tiles to assist engineers and electricians when wiring and fault finding.  These terminal blocks are available to order individually. Approvals - ATEX - IEC 60079-0, ATEX- UL 60079, CCCEx - CNCA-C23-01, EAC - TP TC 012/2011, IECEx - IEC 60079, INMETRO – IEC 60079

?

Green/Yellow Ground Terminal Block with Pushbutton Features

• 3 copper conductors, single level
• Test port
• Direct plug-in of rigid and flexible conductors with end tips
• Pushbutton operation
• Push-in cage clamp technology
• Ex Approved
• Front entry wiring
• Wire size 20- 6 AWG, Nominal cross section 10 mm²
• DIN Rail mounting 35 x 15 mm & 35 x 7.5 mm
• Dimensions HxWxD – 89 x 10 x 36.9 mm
• Green/yellow Polyamide (PA66) construction
• Operating temperature -60 to +105 °C
• Ex Approvals - ATEX, CCCEx, EAC, IECEx, INMETRO

What are DIN Rail Mount Terminal Blocks used for?

DIN rail mount terminal blocks are designed to allow engineers and electricians to connect electrical circuit wiring to supply systems and other pieces of equipment such as motors, power supplies, fuses, etc.

Terminal blocks are one of the most widely used electrical connection products used within industrial electrical supply installations, establishing a semi-permanent link in an electrical supply system allowing power to pass around a circuit. Feed through terminal blocks also facilitate easy replacement and expansion should the demands of the system change.